The application of the Ore Milling Equipment powder is ubiquitous, to achieve the coating, metallurgical small to the daily use of cosmetics, are required to use a variety of different powder, so the use of stone mill is also very much. In order to make the production of powder more high quality and stability, many manufacturers will buy good reputation good quality grinding mill to use, in fact, in addition to these, pumice mill in the course of the use of maintenance and maintenance is also Very important.
In the production of Ore Milling Equipment grinding, the life of stone mill depends on the degree of wear of the wearing parts, the replacement of the wearing parts is a normal natural law. So the use of stone mill in the process, the stone mill near the professional operators have to have custody, and they also need to carry out technical training before the job, can be very familiar with the performance of stone milling machine and standardized operating procedures. When the stone mill used for some time, is the need for downtime maintenance, maintenance personnel will be grinding roller grinding blade blade and other wearing parts of the degree of wear and tear to conduct a comprehensive assessment, if you need to replace the time should be replaced. And they will also check the degree of stability of the bolts and nuts, after checking the tightening should immediately tighten, and then add grease. It should be noted that the grinding mill grinding machine used more than 500 hours to replace the roller, the roller sleeve of the rolling bearing must be cleaned, the damage should be promptly replaced, the fuel can be used manually pump And butter guns.
In addition, the use of Construction Waste Crusher in the process also need to pay attention to the regulation of fineness, the production workers need to material according to the filial piety hard, water content, the proportion of different pumice mill processing thickness is also different, adjustable The top of the analyzer, high speed, high fineness, low speed, low fineness. And stop the pumice mill machine, stop the feed, the host continues, so that the remaining abrasive to continue grinding, about a minute later, you can turn off the host motor and analyzer motor, stop pumice mill grinding work, And then stop the fan motor in order to blow the residual powder. Some of the above measures can help manufacturers in the stone mill production process, to minimize the wear of stone mill parts, so that the process of grinding more safe and efficient.